Some details before the description.

This prop is modeled as the old Wayne 70 style pump as reference. While those pops were usually about 7.5 foot tall I made a decision to adjust the height.

For toy photography and dioramas it does not look scale appropriate to have a 7.5 inch tall gas pump towering over a 6" figure. So when I say this pump is 1:12 scale I mean it has been scaled for 1:12 figures.

Ok to the fun stuff.

I set out to create a fun prop. Keeping true to my rusty grimy real world props. I created this prop with a bendy wire hose for added story telling fun!

You can order this prop two ways.

Painted

Unpainted.

If you purchase this prop painted. It comes yellow with weathering as shown in the listing image.

I print, paint weather and seal each piece. From start to finish this design is printed in resin and completed by hand. I have created a fun set of vintage style signage to decorate the pump with.

If you buy the prop unpainted. Know that you will need to install screens (included), glue trim (trim included), install a bendy wire (included) for your pump handle. The decals will be included but you need to install those also.

This pump stands approximately 7" tall. it is approximately 3" wide and 2" deep

Once you make your purchase I print your item. At this point there are no refunds. I make this for you at the time of your order. So please ask questions before your purchase. I know it sounds absurd to have to say "this is not a real pump" this is not a toy "this is a diorama piece" for your dollhouse. This is a miniature toy photography accessory.

This purchase is for one gas pump. It will be either painted or unpainted. No props, figures or other accessories are included. Thanks for your support.